The Elite Falcon Electronic Speed Controllers 145/200/220 contains a driven output for the external fan (5V, up to 300mA). It is activated as soon as the controller temperature reaches 55°C. Take a look at the diagram below to see how it is properly connected.
Note: If the pins are misaligned, a result of the fan spinning backwards (connected one pin over) or the fan running continuously (connector is upside down) will occur.
Check out how we used the Multiplex MPX 90 degree connectors in our most recent installation!
These guys can support anywhere from 2 to 4 servos.
Find them here!
Check out this motor and ESC installation we finished! This beautiful hotliner was in need of some decent equipment, but space was clearly an issue. To solve that problem, we direct soldered the Jeti Phasor Motor and Jeti Mezon ESC with an inline configuration. This type of soldering job allowed us to keep the motor and ESC in a straight line, and close to each other, leaving room for the batteries. Check it out below!
